These engines are custom built from a bare casing useing
72mm relined ts 1 barrel
72mm cyl head and 72mm rb asso piston
af 60mm stroke high performance crankshaft and ina little end bearing
fag crankshaft bearings and viton oil seals
solid oilseal plate
ca sa rear wheel bearing with mb oilseal
italian layshaft and german gearbox bearings
close ratio gearbox
6 plate clutch with lightened rear sprocket
iwis chain and uprated chain support
all casings vapour blasted using stainless fixings throughout
120 w bgm stator and intermediate flywheel
mb adjuster block and ss adjusters
mb ss pivot and swivel
mb ssclutch arm
mb rear brake arm
mb ss mag wire plate
uprated and extended engine mounts and bar
italian rear hub with ss lock ring and nut kit
sintered rear brake shoes
one piece rear brake cable
tsi reinforced cyl cowl and fan cowling
franspeed 3 exhaust comes with our own 3 point rear fixing bracket and bolt on tail pipe
35 tmx carb kit cable rubber and clips jets and needles
oil and plug
this engine is ready to fit and has been tried and tested on my own scooter spec can be changed to suit your requirements please contact us if you require any more info .
